What Common Mistakes Should New Rig Operators Avoid? – hnironrubikcubemachine.com

Every operator starts somewhere, but errors can be costly—especially when working with a SANY used rotary drilling rig or XCMG used rotary drilling rig. Whether using a second-hand rotary drilling rig or a reconditioned unit, here are five common mistakes to avoid.

1. Ignoring Pre-Shift Inspections

SANY used rotary drilling rig systems rely on clean hydraulics and intact wiring. Skipping checks causes sensor failure or leakage.

2. Misjudging Ground Conditions

New users often apply too much torque in soft soil. Match the bit and pressure carefully—especially for XCMG used rotary drilling rig with less auto-adjust.

3. Improper Shutdown Procedures

Some reconditioned rotary drilling rig units have custom shutdown sequences. Not following them can lock up systems or reset controls.

4. Overdrilling or Stalling

Newbies sometimes let a second-hand rotary drilling rig run too deep or too slow. Watch depth gauges and torque warnings at all times.

5. Lack of Operator Coordination

Never assume others know your movements. Miscommunication leads to safety hazards around any SANY used rotary drilling rig.

Get it right from the start—learn from experience and trusted sources. Visit hnironrubikcubemachine.com for operator training and equipment support for reconditioned rotary drilling rig and second-hand rotary drilling rig tools.

READ MORE：